Chevy Steering Wheel Bowtie Emblem Overlay Kit || Cut-Your-Own || FREE EXTRA SHEET || 3M Vinyl
Extra Overlay Sheet Allowing for any mistakes, or use the extra sheet for another emblem.
2014 - 2018 Impala
2013 - 2018 Malibu
2015 - 2018 Tahoe
2014 - 2018 Silverado
For other make/models, measure your emblem size, if it is not larger than 2" inches X 3" inches, this kit will work for your make/model (application instructions are the same for Steering Wheel application).
(2) TWO 3”W x 2”H sheets of Auto Wrap Vinyl.
About The Vinyl:
Up to 8 Year Durability, 3M Carbon Fiber Vinyl - Outdoor Rated, Water and UV Resistant. Air-Egress Technology. Bubble Free Air Channel, No-Mess adhesive for easier application and simpler removal. The vinyl can be removed at any time with no damage to the vehicle. Ready to use right out of the package! Perfect for Do It Yourselfer’s.
100% Satisfaction Guaranteed.
Tools Needed and NOT Included:
Bladed Utility Knife or Razor Blade Plastic Card
How to Install: Thoroughly clean the surface (isopropyl alcohol is best). When dry, peel the paper backing from the vinyl and align the vinyl to the emblem, covering the gold part of your emblem. Press firmly on the vinyl. Check for major creases or air bubbles. Use a plastic card or your finger nail to go around the emblem, making a crease. This crease line is going to guide where you cut. Peel off the excess material. Peel slowly looking for any areas that might not have cut all the way through. If you made a mistake, no worries we give you (2) overlay sheets. The vinyl is heat activated. The longer it can cure in direct sunlight the better (1-2 hours is good) or apply heat from a hair dryer or heat gun.
Helpful Tip: Apply in temperature that is 50 degrees or more.
INSTRUCTIONS WITH EVERY ORDER